Blogs — Bitmain Antminer

How to reset miner to factory settings

Автор публикации: Support Bit2miner, дата:

Tutorial Video Link: https://youtu.be/x6Yw-J0MTuE This applies to all Antminers. There are three ways to reset to factory settings:  1. Restore via "Reset" button This method can be applied within 10 minutes when the miner boots. After powering on the miner for 2 minutes, please press "Reset" button for 5 seconds, then release it. The miner will be restored factory settings within 4 minutes and automatically restart (no need to power off the miner). 2. Restore via software Log in to your miner user interface, click Upgrade > Perform reset, then click “OK” on the pop up window.   3. Restore via...

Подробнее →

Miner normal operating temperature range

Автор публикации: Support Bit2miner, дата:

To be specific, the temperature of the miner's intake air should fall within this range.  Even if the room temperature is cool, the intake air temperature might still be too high because of the dust accumulation or other reasons. Please clean the miner if needed. How to clean and dust my miner > Different models display the miner's temperature differently. Notably, most of our miners have a protection program that puts the miners to shut down at temperature too high. High temperature alert and protection > Below shows the normal temperature of the miners: Antminer  Temperature in degree Celsius  S9...

Подробнее →

What do Bitmain miner's signal lights mean?

Автор публикации: Support Bit2miner, дата:

What do Bitmain miner's signal lights mean?

Подробнее →

Antminer Operation and Maintenance Guidance

Автор публикации: Support Bit2miner, дата:

This manual mainly tells the related points involved in Antminer operation and maintenance. The related personnel shall be familiar with the basic miner maintenance methods, including system upgrade, reset, restore, SD card recovery. Meanwhile, mastering simple fault judgment methods, such as high-temperature protection, fan fault, network fault is essential. Operation and maintenance personnel also need to have a certain understanding of the power, network, environment, etc. of the mining farm and regularly do the corresponding inspection work. Finding problems and resolving them timely can reduce the fault rate of the miner. Ⅰ. Daily Regular Inspection II. Notes on Installation Ⅲ....

Подробнее →

How to reload or upgrade firmware

Автор публикации: Support Bit2miner, дата:

This applies to all Antminers, except B3. Check out B3 firmware upgrade instructions > 1. Visit our website to download the firmware.  Visit firmware page > Select the miner from the left side bar and then click "Firmware". You might need to scroll up to see the file. There are different versions of firmware for different miner models. Select the one that is specific for your miner.  Note that we have a new firmware called ASICBoost for S9 series and T9+ miners. For more information, read them here: ASICBoost firmware for Antminer S9 series and T9+ > 2. Download the...

Подробнее →


×
Welcome Newcomer